The walls must be dry, smooth, dust - free, oil-free and in a neutral white color. Close up holes and/or cracks in the wall with a filler and sand them smooth. First treat highly absorbent walls with a fixing primer. A primer , fixation, or a layer of undercoat is recommended, This will reduce possible color differences or stains. It also prevents the risk of wallpaper coming loose when thee is new plastering. Through preparation of the foundation is very important for a thin or light - colored wallpaper references, since there are more sensitive to possible transparency. Placing a plain coated wallpaper as a foundation. When purchasing the various rolls of wallpaper, also note the manufacturing batch, which must be the same for each rol in order to prevent possible color differences.
Carefully follow these next steps:-
Cut the strips to the desired length. Take into account the height of the repeat and whether or not there will be reversing.
Roll the drawing inwards: Apply to the walls a universal ready - to - use wall adhesive .that has an a rylate base, suited for all wallcoverings.
Follow the instructions from the adhesive manufacturer
(1) Adhere the strips next to each other (without overlaping ) and press on them using a brush.
(2) start from the middle and brush to the sides so that all the air bubbles disappear, keep residual adhesive from getting on the wallcoverings. If this does happen, however carefully remore it by dabbing with a moist cloth. (Do not Rub). Cut off the excess wallpaper by the ceiling and the baseboards. with utility knife.
(3) Let dry, avoidings rapid and excerssive warning or drafts during the installation itself.
Quality of non woven wallcoverings and others those were applied in the manner above can be easily removed when dry.
Check the result after applying there strips. Complaints about more than three strips will not be accepted. Further complection is your o wn responsbility . Complaints must be reported immediately and directly to us.